How to use:
1.Product side of the ON / OFF switch, the light will flash that can be work.
2.ON when the product is opened, when not in use leave the switch on the OFF file.
Placing the product on the vehicle visibility areas (such as the right side of the front windshield) This product may be placed in direct sunlight at Selected places, the inside of the low double-sided adhesive paper torn off, the paste is good.
3.Not sensitive to the vibration of the state, usually 6LED alternating light, which is in testing status, a vibration sensor will start the alarm mode after Vibration plus 2 times within 5 seconds, 10 seconds flash mode vibration vibration.
4.Vibration within the first 10 seconds and vibration plus 3 times selected for that switch to stop the state does not light within 60 seconds.
1.Please do not put in the hamper and impede the drive where safety devices (such as airbags, seat belts). This product LED lights can not be replaced.
2.If parking can not be sunshine place, set the button on the product OFF.
3.In the OFF mode during the day and will be automatically charged.(NOTE:The first use unless 5 hours charging available)
4.This Solar Car Burglar Alarm Just work on night.When open the switch, after 2 minute then work.
5.According to climate and environment, there will be in charge of discontent during the day happen, When there is no sunlight can not be fully charged case, according to drying in the sun a little longer before using.
- 6 LED lights, the night can see from the car, can serve as an effective deterrent effect. Built-in vibration sensor is, as long as the perception of vibration, 6 LED lights will be opened and issued a strong light.
- Built-in automatic light during the day automatically stops, automatic control of lights after dark. Automatic charge mode automatic charging during the day, will automatically control the lights after dark.
- In the OFF mode during the day and will be automatically charged.Just work on night.
- Products taken out can only use double-sided adhesive stickers.With a neutral detergent to clean the place paste After the glue on both sides, about 24 hours to reach the most viscosity Do not double-sided adhesive attached to the place dirty or rough surface.
- Size:2.3″x1.2″ Weight: 55g